 |
 |
|
|
Communication Option Boards
Communication Option Boards add versatility to the Kingfisher PLUS+ RTU. The option boards plug into the communication or processor module and can be changed by opening the module case, unplugging one option board and then plugging in another.
CP-10/11/21, MC-10/11 and LP-1 modules all use the same version of communication option boards. Some option boards are supported by all these modules and some are not (as detailed in the title for each option board).
CP-xx/MC-xx/LP-1 option boards are not interchangeable with PC-1/MC-1 option boards.
CP-10/11/21 and MC-10/11 modules can have option boards installed on ports 2 and 3 while LP-1 modules can have one option board installed on port 4.
*Option available via MC module
** LP-1 uses 900MHz AU/US Option only
*** Port restrictions apply - see product details
|
|
There are 10 products in this category.
|
Option R - Spread Spectrum Featured Popular
Features:
The spread spectrum communications option allows you to reach that remote device or system that would prove too difficult or costly with cable. This radio uses the public frequency band and does not need to ...
|
|
Option A - Fibre Ethernet CP-10/11 Popular
Features:
The fibre optic ethernet option board (F) provides ethernet functionality over a fibre optic link. The board supports UDP or TCP/IP standards and can communicate up to 100Mbit/s.
...
|
Option D - Dialup Modem Popular
Features:
The dial option board 'D' provides a V34 PSTN interface. The port speed is software configurable. The dial option board is designed to be compliant with British standards that are also used in Australia and ...
|
Option E - Ethernet CP-21 Popular
Features:
The Ethernet option E board provides the RTU with TCP/IP communication over UTP unshielded twisted pair cabling.
- UTP Ethernet option board for CP-21
- 10 ...
|
Option F - Fibre Serial Popular
Features:
The fibre optic option board (F) provides an RS232C serial interface via a fibre optic cable. A fibre optic port is treated the same way as a standard serial port except a fibre optic cable is used for the ...
|
Option H - HART CP-10/CP-11 Popular
Features:
The Hart option board provides a Bell 202 interface to devices supporting the Hart protocol.
Each Hart option board can be used to communicate with up to 15 Hart devices. When communicating with a sin ...
|
Option I - Isolated Serial Popular
Features:
The isolated serial option board (I) provides an RS232C, RS485 or an RS422 serial interface. The port is software configurable for any of these modes.
RS485 requires a 120-Ohm terminating resis ...
|
Option J - Image Capture Popular
Features:
The Kingfisher Image Capture device is used to capture and send images over an existing Kingfisher RTU/SCADA communications network.
Image capture can be initiated via an RTU ladder logic comma ...
|
Option L - Line and Radio FSK Popular
Features:
The line option board provides a Private Line or Radio interface and is software configurable for either of these modes. There are two revisions of the line option board.
The original revision 'LINE-L ...
|
Option T - Ethernet CP-10/CP-11 Popular
Features:
The Ethernet option board (T) provides ethernet functionality over UTP unshielded twisted pair cabling.. The board supports UDP or TCP/IP standards and can communicate up to 100Mbit/s.
...
|
Results 1 - 10 of 10
|
|
|
